Various output refractory spraying machine for sale
2021-11-18 17:23:10
Various output refractory spraying machine for sale
Various output refractory spraying machine is widely used for spraying refractory materials for lining kilns, boilers, furnaces, steel plant, cement factory, degasser lining etc. And it also could be used for heat and cold repair of vacuum degasser linings.
With the rotary gun, materials is placed in the gun gopper where it feeds into a wheel with pockets at the base of of the hopper, the wheel turns by motor driven gears powered by electric or compressed air. When the feed wheel rotates, the loaded pockets pass under an air inlet section which forces the refractory material to the outlet and into the feed hose in steady flow. The refractory material passes along the hose to the nozzle, where it is mixed with water and sprayed onto the pump.
Electric engine various output refractory spraying machine for sale:
The rated output of LZ-3ER refractory spraying machine is 3m3/h, its electric engine power is 4Kw, its operating air pressure is range from 2-4bar, its local voltage are respectively 3phase, 380V, 50Hz, and its max horizontal conveying distance is 100m.
The rated output of LZ-5ER refractory spraying machine is 5m3/h, its electric engine power is 5.5Kw, its operating air pressure is range from 2-4bar, its local voltage are respectively 3phase, 380V, 50Hz, and its max horizontal conveying distance is 100m.
Air motor various output refractory spraying machine for sale:
1. In order to prevent the remaining material from condensing in the hopper, hose and nozzle, blocking the hose and nozzle, affecting the service life of the equipment. After the work is completed, immediately drain the remaining material in the hopper, and pour enough clean water into the hopper to thoroughly clean the hopper, and then start the machine to pump the water out to clean the hoses and nozzles until all clean water is pumped out.
2. Adjusting and homing: After the refractory spraying machine has been working for a period of time, the rubber plate, steel lining plate and other parts will inevitably produce a kind of friction and form a gap. At this time, you need to manually adjust to return to the original position.
If you want us to recommend a suitable refractory shotcrete machine for you, please help us confirm the following questions:
1. What's the project you will use the machine do?
2. What is the output do you need? 3m3/h, 5m3/h, 7m3/h, 9m3/h?
3. Drive type mode? Do you want electric engine or air motor?
4. Do you have any other special requirements for this machine?