High flow rate peristaltic pump with rubber hose
2021-03-17 17:10:45
High flow rate peristaltic pump with rubber hose
1. Before disassembling the high-flow peristaltic pump, mark the left and right air chambers and liquid chambers respectively for subsequent reassembly.
2. Connect the outlet pipe with a wrench, loosen the small clamp with liquid chamber, remove the outlet pipe to see the valve ball and valve seat, take out the valve ball and valve seat, and check other parts of the pump for wear, chemical corrosion and cracks.
Advantages of peristaltic pump with rubber hose:
1, convenient installation, simple operation, and continuous long-time operation;
2. The cutting sensitivity, abrasiveness or gas-liquid-solid mixture of various fibers and slurries sent in the pump are selected, and the material diameter is greater than or equal to 4-6 mm;
3. It can easily erode fluid, highly viscous, high-density fluid and pasty fluid in the pump;
4. Replace seals, gaskets, impeller rotors, stators or traditional pump internal components for hose pumps;
5. When the pump moves clockwise and clockwise, there is no backflow and siphon phenomenon, and it has the function of cut-off valve. When it reverses, the fluid can be sent out and sucked back;
6. The pumped fluid is proportional to the rotating speed and can be accurately measured.
1. The high flow rate peristaltic pump with rubber hose is a positive displacement pump, and the flow rate of the pump is determined by the output speed of the driving device. Due to the structure and material of the pump, the speed is not easy to be too high, and the speed should be less than 50 rpm.
2. When the process is continuous operation, the actual flow rate should be basically consistent with the rated flow rate of the pump. If operation is required, the pump with adjustable speed should be selected for the change of flow rate, and the rated flow rate of the pump should not be used for large flow rate.
3. When the process is gap operation and there is no quantitative requirement, the rated flow of the pump can be larger than the actual required flow. If there are quantitative requirements, the rated flow rate of the pump should be basically consistent with the actual flow rate. If the actual flow rate of the pump is greater than the required flow rate, bypass pipe can be added for adjustment.
4. The rated pressure of the pump refers to the working pressure of the pump equipped with a certain power motor. The actual working pressure of the pump is determined by the pipe resistance loss of the pump itself. Therefore, in operation, the actual working pressure of the pump should not be greater than the rated pressure of the high flow rate peristaltic pump with rubber hose.
5. The service temperature of ordinary hose is < 100 C, considering the heat generated by moving parts during operation, it is generally used for workers whose material temperature is < 80 C. If the material temperature is allowed to reach 100 C under the condition of ventilation (or cooling), if the material temperature is > 100 C, heat-resistant hose should be selected.
6. Because the pump is a type of pump, it has pulsation when conveying materials.
7. The high flow rate peristaltic pump with rubber hose is allowed to run idle for a short time.
Phone/Wechat
ADDRESS
contacts
+86-18538591025
sales@leadcrete.com
中文
English
Your Position： 
(Live chat)
.jpg)
.jpg)
Whatsapp
