Phone/Wechat
+86-18538591025
ADDRESS
Xisihuan Ring-Road East, Tielu, Xiliu Lake sub-district, Zhongyuan District, Zhengzhou, Henan China
Grouting pump is more and more recognized by grouting users in engineering grouting. Now, grouting pump is widely used in high-rise building gray mortar conveying reservoir, port, pier and other pressure grouting, foundation treatment, weak foundation Reinforcement grouting, however, there is a novice to buy back to the injection pump when there is no practical experience, their blindly groping, do not know how to operate the grouting pump, to this end, the company's technical department to the majority of the new purchase of injection pump Of the customers made the following recommendations, hope to be able to help everyone.
How to operate the grouting pump? Technical staff that no experience in the user, it is best to go through the training of professional skills, do not arbitrarily operate the pump to cause serious consequences. Even a professional operator, in the operation of the injection pump, also need a detailed reading of the manual, a serious study, research how to operate more accurate. On the contrary, if not a professional operator, not through professional skills training, so that users can read the instructions in detail, do not miss every detail, encounter problems to find relevant personnel to solve. Therefore, do not think that something will be their own, and to operate some strange pump, and finally cause serious accidents.
If when the use of mining high pressure injection pump, showing the situation of fracturing, severe time will damage the machine. This phenomenon of professional technical staff that this is mine pressure injection pump pressure control is not good, if this function is not in place, it can’t stop the slurry in the activities of the gap between the gap and the gap, Damage the machine. Deal with this question is not difficult, has been purchased mine high pressure injection pump users can come back from scratch manufacturers, so that technical staff transferred a pressure. If you have not yet purchased a decent mine high pressure grouting pump, you can pick a strong pressure of the machine, and the machine can be self-grasping, and will not be damaged in the work of the machine may block the situation.
How to properly use the injection pump engine, critical pump injection engine is a device power function, the equipment is small, but can’t be ignored. Proper use of the engine is the key. Before running, should make the bearing and other lubrication parts to be lubricated. After the start of the water temperature should reach 40 ℃ -50 ℃ and then put into operation. It is forbidden to overload or low speed for a long time. Before unloading, you should first remove the load to reduce the speed. After the winter parking should be dropped to 40 ℃ -50 ℃, the net cooling water has been given anti-antifreeze in addition to the engine. Usually have to do a good job of the engine maintenance work, so that the machine has always maintained a good state of operation. To observe, check, find fault, promptly ruled out. Use the right to extend the service life of the equipment.
Pre:Gunning machine for refractory price
Next:The different between foam concrete and aerated concrete